
XFire Solution. Full chimney sweeping, inspection, and repair for Boise homes, drop cloths down, dust contained, and a straight answer on what your chimney needs.
Boise is home base. We are on 28th Street and fully mobile across the city, so a sweep or an inspection here is a local call rather than a dispatch from two valleys over.
The thing about Boise is that it is really four or five different chimney problems wearing the same roofline. A North End bungalow built before the war has almost nothing in common with a Harris Ranch house finished in the last ten years, and a wood stove heating a place up Bogus Basin Road is a different animal again. They fail in different ways, on different schedules, and they need different work.
What does not change is the method. Drop cloths down, the flue swept out, dust kept inside the equipment and not in your living room, and a straight read on what the system actually needs when we are done. Nothing more than that.
Full flue sweep and creosote removal, dust contained.
Learn moreA straight read on what your chimney actually needs.
Learn moreKeep rain, animals, and downdrafts out of the flue.
Learn moreCracked crowns, bad mortar, and worn parts fixed.
Learn moreWood stoves and fireplaces cleaned and checked.
Learn moreLint pulled from the vent line, the other fire risk.
Learn moreBoise's oldest neighbourhoods are full of real masonry chimneys, and most of them are now somewhere between eighty and a hundred and twenty years old. The usual story is a clay tile liner that has started to crack, a crown at the top that has taken decades of freeze and thaw and finally split, mortar joints that have gone soft, and a damper rusted into whatever position it was last left in. None of that is dramatic on its own. Stacked together it is how a chimney starts letting heat and combustion gas somewhere it should not go, and you will not see any of it from the hearth.
A lot of Bench and Southeast Boise houses were built in the fifties and sixties with an open masonry fireplace, and then had a wood insert pushed into that opening during the energy crunch of the seventies and eighties. Very often that insert was never given its own liner, so it vents into a flue many times too large for it. That combination is the single most common genuinely unsafe setup we find in this city: the flue never gets hot enough to stay clean, so creosote builds fast and builds glazed. If your fireplace has a metal box sitting inside a brick opening and nobody has ever mentioned a liner to you, that is worth an inspection on its own.
Newer Boise building is mostly factory-built: a metal firebox in a framed chase, or a sealed direct-vent gas unit. These do not fail like masonry. What goes wrong is the chase cover rusting through and dumping water down the chase, a cracked refractory panel in the firebox, a storm collar that has let go, or a gas unit that has never been serviced and is burning dirty and sooting its own glass. They still need annual attention, just not the same attention.
Homes sitting up on the foothills catch wind the valley floor never sees, and a cold flue in a well-sealed modern house will happily run backwards and pull smoke into the room instead of up the chimney. If your fireplace smokes on the first light and then settles down, that is usually a draft and make-up air problem, not a dirty flue, and the fix is different.
Boise's chimney season really starts in September, and the whole valley calls at once in the first genuinely cold week of November. A sweep booked in late summer goes in that week. The same sweep booked on the first freeze goes in whenever there is room. On top of that, the Treasure Valley sits in a bowl and gets winter inversions that trap smoke at ground level, which is why Ada County puts burn restrictions in place on the worst air days. Idaho DEQ runs a burn line at (208) 373-0313 and publishes the current status at deq.idaho.gov, and it is worth checking before you light anything on a still, grey January day.
“We hadn’t had a working fireplace since we moved in over two years ago, so finally getting it serviced felt long overdue. We called XFire Solution based on a personal recommendation, and they completely delivered.”
“This company’s employees really care about your happiness.”
“We had the absolute best experience with XFire Solution! I highly recommend them!”
Tell us about your chimney and when it was last swept, and we’ll get right back to you with a straight answer and a free quote.