
XFire Solution. Chimney sweeping, inspection, and repair for Meridian homes, done clean, with an honest read on what your system needs.
Meridian is a short run from our Boise base and we are out here constantly, which is the whole point of being a Treasure Valley company rather than a Boise one.
Meridian is also the town where the usual chimney advice stops applying. Most of the city went up after the mid-nineties, and that means the fireplace in the average Meridian house is not a masonry chimney at all. It is a factory-built metal firebox sitting in a framed chase, or a sealed direct-vent gas unit. Both are perfectly good systems. Both need servicing. Neither one fails the way the hundred-year-old brick in Boise's North End fails.
So the job here is usually a different job, and anyone who turns up with only a brush and a set of masonry rods is not going to be much use to you.
Full flue sweep and creosote removal, dust contained.
Learn moreA straight read on what your chimney actually needs.
Learn moreKeep rain, animals, and downdrafts out of the flue.
Learn moreCracked crowns, bad mortar, and worn parts fixed.
Learn moreWood stoves and fireplaces cleaned and checked.
Learn moreLint pulled from the vent line, the other fire risk.
Learn moreA prefab firebox is a metal box lined with refractory panels, venting into a metal chimney that runs up inside a framed chase. The things that go wrong are specific. Refractory panels crack and that is a real problem, because those panels are what stop the firebox shell from overheating. The chase cover on top, which is the big metal lid the chimney pokes through, rusts and then funnels water straight down inside the chase where you cannot see it. The storm collar and the cap let go. The whole system is also manufacturer-specific, so the parts have to match the unit rather than being generic.
A lot of Meridian homes have a sealed gas fireplace behind fixed glass, and because there is no ash and no smoke people reasonably assume there is nothing to do. There is. The glass gasket seals and should be checked, the glass itself hazes over from normal combustion, the burner ports clog, the pilot and thermocouple foul, and the ceramic logs have to sit in exactly the positions the manufacturer specified. Logs nudged out of position are the single most common cause of a gas fireplace sooting badly, and soot on a gas appliance means incomplete combustion, which is a carbon monoxide conversation, not a cosmetic one.
There is still genuine old Meridian around Main and Pine, and those houses have proper masonry chimneys with the same age-related problems as anywhere else in the valley: cracked crowns, soft mortar, tired clay liners and dampers that have not moved in years. We work on both kinds, which in a town this mixed matters more than it sounds.
Meridian books up the same way the rest of the valley does, which is to say everybody calls in the same fortnight in November. If your fireplace has not been touched since you moved in, and in a city that has grown as fast as this one that is an extremely common answer, the time to find out is before the first cold snap, not during it. Winter inversions settle over the whole Treasure Valley, so Ada County burn restrictions apply here too; Idaho DEQ publishes the status at deq.idaho.gov and runs a burn line on (208) 373-0313.
“We hadn’t had a working fireplace since we moved in over two years ago, so finally getting it serviced felt long overdue. We called XFire Solution based on a personal recommendation, and they completely delivered.”
“This company’s employees really care about your happiness.”
“We had the absolute best experience with XFire Solution! I highly recommend them!”
Tell us about your chimney and when it was last swept, and we’ll get right back to you with a straight answer and a free quote.